Monaco LaPalma, Руководство пользователя

Страница: 265 / 366

6 • 265
Water Systems
2004 • LaPalma
If you choose to fill the water lines with antifreeze, you will need 5 gal-
lons of FDA RV winterizing antifreeze.
1. Remove water faucet filter cartridge and replace filter with
diverter hose (see FAUCET WATER FILTER). Diverter hose
comes with motorhome and will be stored inside. Diverter hose
installed creates a bypass in the water lines.
2. Drain the fresh water tank and lines by opening the tank drain
valve and the low point drain valves located in the outside water
control service compartment of the motorhome. Position the
water tank fresh water valve in the “Fresh Water Tank” setting.
3. Let all the water drain. Turn the pump on and allow it to run so
that all the water is cleared out of the pump and water tank. Turn
the pump off.
4. Remove water heater drain plug and open pressure release valve
located in the outside water heater access compartment.
5. After the water is drained, move water heater bypass valve to
BYPASS setting located next to water heater. Replace the water
heater drain plug and close the pressure release valve.
6. Close the fresh water tank drain valve and the low point drain
valves.
7. Close the water tank shut off valve.
8. Install a hose to the city water hook up and drop the other end of
hose into the antifreeze container.
9. Turn ON the system water pump and operate each faucet
individually until a small amount of antifreeze is present.
10. Close the faucets.
11. If applicable, winterize the washer/dryer (see WINTERIZE THE
WASHER/DRYER).
12. Open the shower faucets and flush toilet to allow a small amount
of antifreeze to run into the holding tanks.
13. Use a soft cloth to wipe out the sinks and shower to protect surface
from antifreeze stains.
14. Exterior faucet should be opened and closed using the same
procedures as the interior faucets.
15. If the motorhome is equipped with an ice maker, remove the
valve outlet line located in the outside refrigerator access
compartment. Cycle ice maker several times until antifreeze is
present.
16. Turn water pump off.
17. Disconnect the power supply line affecting water pump
operation.
Using Non Toxic
Antifreeze