Monaco LaPalma, Руководство пользователя

Страница: 208 / 366

5 • 208
2004 • LaPalma Equipment
The slide-out system can be retracted in the event of a power loss.
If the room does not move when the switch is pressed:
• The ignition switch is OFF.
• Check to make sure the battery cut-off switch is on.
• Check if the battery is fully charged and connected.
• If locking bars are used, make sure they are removed.
WARNING: Do not work on the slide-out system unless the
battery is disconnected. Make sure the floor is clean before
retracting the slide-out room. Dirt or grit that is trapped under the
slide-out can cause damage to the floor.
After the previous items have been checked, and the room still does not
move when the slide-out switch is pressed, follow these simple steps to
manually override the slide-out room.
Manual Override for Bedroom Slide-out:
1. Lift up the mattress and unscrew baseboard to gain access to the
slide-out cover board and mechanism.
2. Remove 12 Volt DC from the motor by disconnecting the plug
from the slide-out motor to the power supply.
3. The drive mechanism has a sliding coupling to engage and
disengage the drive motor. Turn the large hex nut clockwise to
unlock the drive motor.
4. The slide-out then can be pushed back.
5. Once the slide room has been manually retracted, turn the large
hex nut counterclockwise to lock the room in place.
6. Take the motorhome to an authorized dealer for service.
NOTE: The slide out room is heavy and may require several
persons to push it into the retracted position.
Manual Override
Bedroom Slide-out
020079b