MagKrimp™ Hydraulic Head Crimper
Doc No. TM-190780422
Release Date: 03-28-14
UNCONTROLLED COPY
Page 10 of 22
Revision: A
Revision Date: 03-28-14
Figure 2-1
AIR SUPPLY
CUSTOMER
SUPPLIED
FILTER, REGULATOR,
AND GAUGE
LUBRICATOR
(OPTIONAL)
AIR HOSE
FILTER CAP: RED FOR
SHIPPING AND BLACK
(VENTED) FOR OPERATION
PUMP
DUST CAP
HYDRAULIC HOSE
QUICK DISCONNECT
COUPLER
HYDRAULIC HEAD
ASSEMBLY
CAUTION:
Always disconnect the air supply until the system is ready to operate.
2.1 Set-Up
The principal mechanical parts of the 19078-0422 are illustrated in Figure 1-1 and Section 5 in this document.
Air Supply Hook-Up
WARNING
: Seal all external pipe connections with a high quality, non-hardening pipe sealant. Teflon
tape may also be used to seal hydraulic connections if only one layer of tape is used.
1.
Select the 1/4 NPT threaded fittings that are compatible with your air supply.
2.
Remove the red plastic thread protector from the putt pump on the air connection. Pull out and discard then
attach the air fitting.
3.
Next, install the fittings to the filter, regulator, and gauge unit. The air supply should be 20 CFM (550 L/M)
and 100 PSI (6.9 Bars) to obtain the rated hydraulic output. Air pressure should be regulated to a maximum
of 125 PSI (8.6 Bars). See Figure 2-1.
4.
Before installing the hydraulic hose, unscrew the square nut on the
putt pump outlet and discard. Attach the hose assembly to the
hydraulic fluid outlet.
2.2 Hydraulic Connections and Optional Bench Mounting
1.
Remove the dust cap from the cylinder on the crimp head.
2.
Connect the quick disconnect coupler onto the cylinder inlet on the
crimp head. See figure 2-1.
3.
Replace the red filler cap on the pump reservoir with the black-vented
cap that is supplied with the unit.
4.
To mount the hydraulic head assembly to the optional C-Frame stand,
loosen the three thumbscrews in the stand and place the hydraulic
head in the stand with the cylinder facing up. Tighten the
thumbscrews; making sure the hydraulic head is securely positioned.
See Figure 2-2.
C-FRAME
STAND
HYDRAULIC
HEAD
Figure 2-2
THUMB
SCREW (3)
