BE-20 Bed Extension 20”
Assembly
1. Tap straight end of tapered pin (A) into the centering hole on the bed extension with a wooden mallet.
2. Lift into position and line up tapered pin that is mounted into the bed extension with the matched
centering hole in lathe bed.
3. Mount the bed extension (B) to your JET Wood Lathe with four 3/8”-16x1-3/4” hex socket cap screws
(C), four 3/8” lock washers and four 3/8” flat washers. Snug the screws but do not tighten.
4. Move tailstock over the joint, and line the clamping nut in the center where the two beds meet.
Tighten tailstock clamping lever, and tighten the four hex socket cap screws that connect the beds.
5. The stud that is located at the tailstock end of the lathe bed will need to be moved to the far end of
the extension bed.
WMH TOOL GROUP
Consumer/Light Industrial Products Division
P.O. BOX 1349
Auburn, WA 98071-1349
Ph: 1-800-274-6848
▪
Fax: 1-800-274-6840
E-mail: [email protected]
M-708346 10/02
www.wmhtoolgroup.com
Copyright © WMH Tool Group
