Page 5
4. Operation Method
4.1. Setting of Upper Cover
1) Draw out the “wire arrangement unit (1)” from the main body of the tool to the operator
side.
2) Pull the “setting lever (2)” of the wire arrangement unit toward you, and set the “upper
cover (3)” between the “positioning plate (4)” and the “slide block (5)” in the prescribed
direction.
3) Next, release the “setting lever (2)” slowly and fix the “upper cover (3).”
“Note”
The upper cover uses the concave mark for positioning because there is no directionality.
Setting Direction of 1.0mm Pitch Upper Cover
Positioning plate (4)
Upper cover (3)
Slide block ()
Set lever (2)
Wire arrangement unit (1)
1
2
(N/2)-1
(N/2)
(N/2)+1
(N/2)+2
N-1
N
Cable
[Operator side]
Left
Right
Concave mark
Circuit number
