Page 13
5.5. Adjustment Method of Hand Press Bottom Dead Point
When the adjustment of the bottom dead point is not good enough by the shank alone, the
bottom dead point of the main body of the hand press is adjusted according to the following
procedure.
1) Loosen the “fixed screw (2)” of the “handle block (1)” of the hand press and adjust the bottom
dead point of the main body of the hand press moving the handle block with the “adjustment
knob (3).”
2) Adjust the screw at the same time when there is a “support screw (4)” in the handle block.
3) Set the space of about 0.5mm at the bottom dead point position between the “upper die (6)”
and the “stopper (5).”
“Note”
Please note that there is a case of the tool damage when the bottom dead point of the
main body of the hand press is adjusted low too much.
Handle block (1)
Fixed screw (2)
Stopper (5)
Support screw (4)
Adjustment knob (3)
Upper die (6)
