Mohawk TR-33, Руководство пользователя

Страница: 18 / 87

MOHAWK MODEL TR-33/35/50/75/33WT/35WT/50WT/70WT
18
INSTALLATION INSTRUCTIONS
ASSEMBLE THE TWELVE HYDRAULIC LINE
ASSEMBLIES MARKED ONE, TWO, THREE, AND
FOUR ONTO THE CARRIAGE AND TRACKS. DO NOT
CROSS THREAD OR OVER TIGHTEN THE
CONNECTORS.
ASSEMBLE THE SIX 40.50 IN HYDRAULIC HOSES
TO THE FORE AND AFT END OF THE UNIT.
(CONNECTIONS ON THE MAIN SIDE TRACK .FROM
THE CARRIAGE TO THE CROSS RAIL )
MOVE THE CONTROL CONSOLE INTO PLACE
BESIDE THE MAIN SIDE TRACK. ( CENTERED,
APPROXIMATELY FOUR FOOT FROM THE TRACK )
ASSEMBLE
THE FOUR HYDRAULIC HOSE
ASSEMBLIES FROM THE CONTROL CONSOLE TO
THE MAIN SIDE TRACK.
ASSEMBLE THE HUBBLE PLUG FROM THE
CONTROL CONSOLE TO THE SELF LEVELING
DEVICE.
IMPORTANT
x
AT THIS TIME HAVE A QUALIFIED LICENSED
ELECTRICIAN CONNECT THE POWER SUPPLY
TO THE CONTROL CONSOLE.
IMPORTANT
USING THE TEXT AND DIAGRAM, FAMILIARIZE
YOURSELF WITH THE CONTROL CONSOLE
FUNCTIONS.
PRE-STARTUP
x
INSURE ALL HYDRAULIC CONNECTIONS ARE
PROPERLY TIGHTENED.
x
PLACE THE AUTO / MANUAL SWITCH ON THE
CONTROL PANEL CONSOLE TO THE
MANUAL
POSITION.
x
PLACE THE HIGH / LOW SWITCH ON THE
CONTROL PANEL CONSOLE TO THE
LOW
POSITION.
x
VERIFY THE MOTOR ROTATION.
x
ENSURE ALL DEBRIS AND PERSONAL HAVE
BEEN REMOVED FROM THE LIFTING AREA..
x
PLACE THE POWER UNIT STARTER SWITCH ON
THE CONTROL PANEL TO THE
ON
POSITION.
OBSERVE THE POWER INDICATOR LIGHT.
FOLLOWING THE PROCEDURES FOR RAISING AND
LOWERING THE UNIT, RAISE THE UNIT
APPROXIMATELY ONE FOOT. INSURE THAT THE
TRACKS HAVE SEATED THEMSELVES INTO THE
ALIGNMENT TABS ON THE CROSS RAIL ADJUST AS
NEEDED.
CYCLE THE UNIT TWO TO THREE TIMES. OBSERVE
EVEN AND SMOOTH OPERATION USE THE
PROVIDED SHIMS TO LEVEL POST ONE, TWO,
THREE, AND FOUR.
ASSEMBLE THE TWO TRACK STOPS TO THE FORE
END OF THE MAIN AND OFF SIDE TRACK USING
THE EIGHT 3/4 - 16 NF X 3 - 1/2 IN BOLTS AND 3/4 -
16 NF NYLON LOCK NUTS.
CHECK ALL HYDRAULIC FITTINGS FOR LEAKS.
TIGHTEN AS REQUIRED.
SNAP INTO PLACE THE FOUR CARRIAGE ACCESS
COVER PLATES ONTO THE CARRIAGES
ASSEMBLE THE FOUR HYDRAULIC LINE COVER
PLATES ONTO THE CROSS RAIL USING THE
TWELVE HEX HEAD 5/16 - 24 NF X 5/8 IN SELF
TAPPING BOLTS.
FOLLOWING THE INSTRUCTIONS FOR RAISING
AND LOWERING THE UNIT, AGAIN CYCLE THE
UNIT. AFTER RAISING THE UNIT FULLY LOWER
THE UNIT.
WITH THE UNIT FULLY LOWERED, ADJUST ALL
FOUR EQUALIZING CHAINS TO REMOVE ANY
REMAINING SLACK. ALL FOUR CHAINS ARE TO BE
TAUT
.