INSTALLATION INSTRUCTIONS
2
INSTALLATION OF SHROUD ASSEMBLY
1.
Apply 1/4” bead of plumber’s putty (not supplied) around lower
flange of spray nozzle assembly. Hand tighten spray nozzle
shroud onto spray nozzle assembly.
CAP
HANDLE SCREW
HANDLE
CARTRIDGE NUT
ESCUTCHEON NUT
ESCUTCHEON
TRIM RING
DIVERTER VALVE
Shroud
Spray Head
Assembly
INSTALLATION OF WASTE TRIM
1.
Place seat cover
(not included in chrome models)
into Seat and push
carefully down. Be careful not to bend seat cover.
2.
Screw drain plug head piece firmly onto drain plug base. Be careful not to
cross thread the part. Ensure that o-ring is correctly seated on head piece.
INSTALLATION OF LIFT ROD ASSEMBLY
1.
Thread mounting tube into the lift rod escutcheon. Place
the rubber washer below the lift rod escutcheon.
2.
Insert the mounting tube through the bidet lift rod hole
from above. Place the metal washer on the mounting
tube. Thread the mounting nut onto the mounting tube
and tighten.
3)
Connect the pivot rod to lift rod strap using spring clip as shown above.
4)
Place the drain plug into the full open position, flex the spring clip and adjust the lift
rod height so that the knob clears the faucet. Installation is not complete. If lift rod (5)
will not slide through the deck, check orientation of mounting bracket to ensure lift
rod hole is not blocked.
To disassemble waste assembly, reverse steps as listed above. In order to remove
seat cover, use screwdriver to bend snap features back from the inside as shown in
picture above. Do not try to lift seat cover with tool from the outside.
In order to remove seat cover, use screwdriver to
bend snap features back from the inside as
shown in picture. Do not try to lift seat cover with
tool from outside.
Mounting Nut
Lift Rod Escutcheon
Mounting Tube
Metal Washer
Rubber Gasket
Lift rod knob
Spring clip
Lift rod
Lift and pivot
assembly
Gasket
Nut
Steel washer
Pivot rod
Escutcheon
Waste assembly
Correct Disassembly Incorrect Disassembly
INSTALLATION OF DIVERTER TRIM
1.
Remove cartridge nut and escutcheon nut from diverter valve
.
2.
Slide trim ring over diverter valve so that trim ring sets flat against bidet deck.
3
. Place escutcheon over diverter valve.
4.
Install and lightly tighten escutcheon nut. Install and firmly tighten cartridge nut.
5.
Place handle on diverter valve stem and secure with handle screw. Press cap
into place on handle
Pop-up head piece
O-ring
Seat cover
(not included in chrome models)
Seat
