Model Train Technology LSC IIa, Руководство пользователя

Страница: 11 / 28

10
MODEL TRAIN TECHNOLOGY ™
If you never plan to use DCC with your LSC II, you can ignore the first two
number indications. You can also disable this start up sequence by set
FastBoot ON.
The LSC II has two modes. It is either in Animation Mode or Configuration
Mode. If you see any red numbers on the top of the LSC II, the LSC II is in
Configuration Mode. If they are off and the blue light is on, the LSC II is in
Animation Mode.
If the blue light is off, the LSC II power is Off.
To switch between Animation mode and Configuration mode, push and
hold button the LEFT TOP Keypad On/Off button for about 1 second and
release. Pushing this button toggles back and forth between these two
modes. The LSC II will not react to a very quick push. If your push is too
long the LSC II will switch back and forth. After a few tries you will get the
hang of it.
There are two pairs of “number” LEDs on the top of the LSC II. On the left
is the number of the selected Port. When you switch to configuration
mode this will always start at “1”.
To change the port number, push the Up or Down black buttons
on the left side top of the LSC II.
On the right side are the two digits that represent the configured
special effects behavior. There are 99 built-in special effect
options, plus “0” (zero) which is OFF for that port. See the chart.
To configure a Port to behave with a specific special effect, select
the port number on the left and then select the behavior number
on the right side.
Press the SAVE button once to save this to the LSC II. The digits
will blink indicating a successful save. The setting is saved even
when power is turned off or disconnected.