Mobotix D14D, Руководство пользователя

Страница: 64 / 128

64
/126
D14D Camera Manual: Mounting
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Connecting The Camera With Bottom Plate 2.4.4
In order to mount the camera to the bottom plate, use three of the supplied
M4x25 Allen
screws
,
three washers (dia. 4.3 mm)
and the corresponding hex nuts.
Caution
When fastening the Allen screws using the 3 mm Allen wrench, make sure that
you do not scratch the camera dome!
Please 1. exchange the original (short) ethernet cable of the D14D against the extended
1 m (3 ft 3 in) ethernet cable
that is delivered with the wall mount. Guide the
connection cables of the camera
from below (smooth side) through the round
opening of the bottom plate.
Position the camera on the underside of the bottom plate so that the PIR sensor 2.
points in the desired direction and the hole in the housing to the right of the PIR
sensor is situated above a hole in the bottom plate.
Insert the 3.
first M4 hex nut
into the corresponding hole of the bottom plate. Then
use one
M4x25 Allen screw
and a
washer (dia. 4.3 mm)
and
lightly fasten the
screw.
4. Turn the bottom plate over and identify the number
of the hole that has just been screwed in (example:
PIR is pointing ahead > Hole has the number
1
).
Insert the remaining
M4 hex nuts
into the other
holes with the same number (
1
, in this case) and use
the two other
M4x25 Allen screws
with the washers
to mount the camera to the bottom plate.
Mount the camera
housing to the bottom
plate before mounting
the bottom plate itself
PIR sensor of the
camera looks straight
ahead: Position 1