Mobeye ThermoGuard CM2200, Руководство пользователя

Страница: 13 / 32

12
4. CONFIGURATION
To program the Mobeye ThermoGuard, the GSM module must have network
connection. In case only batteries are used, first switch the unit to the program mode.
Next send SMS commands for the configuration. All settings are stored and will be kept
in the unit, even in case the power supplies are removed.
4.1 PROGRAM MODE
If the unit is connected to an external power supply, the ThermoGuard has continuous
network connection and the unit is permanently in program mode.
If the unit is battery-powered the program mode can be achieved by pressing the on/off
button for 5 seconds, until the LED starts flashing red and green. Alternatively, the
program mode can be accessed by (re) inserting the batteries.
First the GSM module establishes network connection. During this time the LED flashes
green/red. Normally this takes 10-30 seconds. Once the connection is established the
status LED starts flashing 1 sec. on/1 sec. off (or stays on continuously in case the first
telephone number has been configured).
In program mode, the device is ready to receive SMS commands. If no correct command
is received for 3 minutes, the GSM module switches off in order to save the batteries.
The unit returns to the low power operational mode.
The program mode is interrupted by pressing the on/off button for one second until the
LED switches off. The unit is switched off completely (disarmed).