Mobeye CMVXI-R, Руководство пользователя

Страница: 22 / 28

21
8.2 SWITCHING ON/OFF
After the previous steps, the Mobeye Outdoor Detector is ready for use.
In order to switch on (arm) the Mobeye Outdoor Detector:
- Hold a tag briefly against the tag reader, after which the exit indication starts.
The exit time takes 120 seconds; hereinafter the sensor is active. In the first 20
seconds, the red LED in the sensor flashes.
In order to switch off (disarm) the Mobeye Outdoor Detector:
- Hold a tag briefly against the tag reader. A short beeps are heard to indicate a
correct disarming. After a few (max. 15) seconds three beeps sound which
indicates that the system has fully completed the disarming process.
In disarmed status the Mobeye Outdoor Detector will not send alarm notifications.
The functions automatic arming and sending low battery messages, remain active.
8.3 CONFIRMATION OF THE ALARM MESSAGE
When the system is triggered it will send alarm notifications. First an SMS text
message is sent to all programmed alarm numbers, followed by a phone call. When
you pick up the phone, you will hear beeps. It is possible to acknowledge the phone
call by answering the phone and pressing any key. The other alarm numbers will not
be called afterwards. This works for most telephones.
By switching off the SMS function the system will only call. This prevents the other
numbers being notified by SMS.
8.4 SYSTEM RESET
To reset the Mobeye Outdoor Detector to its factory settings:
1. Remove the batteries and, if relevant, disconnect the battery pack.
2. Keep (an enrolled) tag against the outside button while reinserting the batteries.
Keep it pressed for (about) another 5 seconds.
3. Release the tag immediately after the LED starts to flash.
4. If relevant, connect the battery pack.
After a successful reset, the status LED will blink green to indicate that the module is
not configured. The tag have been removed from the memory and the security code
is back to factory settings.