14
7.
PROGRAMMING WHEN USING OWN SIM CARD
If your own SIM card is used, programming proceeds via SMS commands. For this
purpose the communication module requires network connection. After
programming the units needs to be mounted and tested as described in chapter 6.
7.1
PROGRAM MODE
The Mobeye fire alarm communicator CM4410 switches to the program mode after
placing the batteries. First the communication module establishes network
connection. During this time the LED flashes green and red. Next it will shortly flash
very fast. Within 10-30 seconds the connection is established and the status LED
starts flashing 1 sec. on/1 sec. off (or stays on continuously in case the first
telephone number has been configured).
During the first 3 minutes, the communication module remains active, ready to
receive SMS commands. After 3 minutes a time-out occurs and the communication
module switches off in order to save the batteries.
7.2
PROGRAMMING THE SETTINGS BY SMS
When using your own SIM card, all settings are programmed in by SMS text
messages:
1.
Make sure the CM4410 is in program mode (please refer to 7.1).
2.
Send an SMS text message with the (security) code and the command.
3.
The green LED blinks 3 times to indicate the successful configuration. In case
of an incorrect command, the red LED flashes 5 times.
SMS messages have the following content:
CODE COMMAND:OPTION
Example:
1111 TEL1:+44772345678
- CODE stands for the security code, factory setting is 1111.
- Do not forget the space character between (security) code and command.
