Standard Guest Paging System User Manual
2.6.5 Test Mode
In test mode, use left/right key to move the cursor, if
choose N and press ENT, it will exit the current interface, if Y
then press ENT, it will enter the test mode, as picture 2.18.
Picture 2.18 Test Mode
After enter test mode as picture 2.19, press upper/lower
key to modify the interval time. Under this mode, the group
ID has to be the second ID of coaster.
Picture 2.19 Enter Test Mode Interface
2.6.6 Initialize
User left/right key to move the cursor, if choose N and
press ENT, it exits the current interface, if Y then ENT, it will
start initialization, as picture 2.20
Picture 2.20 Initialize
16-------------------------
®
(¼)(¼)@@00
Standard Guest Paging System User Manual
2.6.7 Send Mode
Setup send mode as picture 2.21, use upper/lower key to
modify the mode, in total two modes: Internal and External.
The default mode is Internal. If External mode, it will switch to
485 interface with external transmitter to send the data.
Picture 2.21 Setup Send Mode
2.6.8 Modify Frequency
1. Setup link
As picture 1.1, it' s the link interface, put the coasters
nearby T10 paging transmitter, press ENT, as picture 1.2,
which means it is linking. If it links successfully, then half of
the coaster lights will be on. If not, then press ESC to return to
the interface as picture 1.1 shows, press again ENT until it
links successfully.
Picture 2.22 Link Interface
-------------------------17
