MKS Stabil-Ion 370 Series, Инструкция по эксплуатации, Страница: 34 / 122

2 Initial Setup Procedures
2-14
Series 370 Stabil-Ion Instruction Manual - 370119
2.1.6
Replacing Control Unit
Cover
Assuming you have completed
the above instructions, the
Control Unit setup is now
complete. Replace the top cover.
Make sure the door hinge pin is
seated correctly. Replace the four
top cover Phillips head screws (or
three screws plus bracket screw).
2.2 Power Supply Setup
1. With all cables disconnected, check to see that the line voltage selector switches on the back
of the power supply are set to local line voltage. Incorrect settings may cause extensive
damage to the product.
AC Line Voltage between 90V to 130V
For AC line voltage between 90V to 130V
set all switches to 115V as shown to the
right. Use 3A, F, 250V Power Fuse, and
use 2A, F, 250V Degas Fuse (see Note 1).
Replacement fuses are available from the
vendors below, or from MKS at the address listed at the front of this manual.
AC Line Voltage between 180V to 240V
For AC line voltage between 180V to 240V
set all switches to 230V as shown to the
right. Use 1.6A, F, 250V Power Fuse, and
use 1A, F, 250V Degas Fuse (see Note 2).
Replacement fuses are available from the
vendors below, or from MKS at the address listed at the front of this manual.
Figure 2-16 Location of Screws for Replacing Top Cover
NOTE 1 : (115V Nom) Power Fuse is: Littelfuse 0312003XP, or BUSS AGC-3-R, or p/n 009325
Degas Fuse is: Littelfuse 0312002XP, or BUSS AGC-2-R, or p/n 009324
When going from 230V to 115V, two new fuseholders are required: SHURTER FEK031.1666 or p/n 006966
NOTE 2 : (230V Nom) Power Fuse is: Littelfuse 021601.6XP, or SHURTER FSF034.1518, or p/n 009323
Degas Fuse is: Littelfuse 0217001XP, or SHURTER FSF034.1516, or p/n 009322
When going from 115V to 230V, two new fuseholders are required: SHURTER FEK031.1663 or p/n 006965
O
O O
O
IG 2.13 -8
A
B
5.67 -2
745
1
2
3
4
5
6
115V 115V 115V
100/110/115/117/120 V 50/60 Hz
230V 230V 230V
200/208/220/230 V 50/60 Hz