First version
Rev 1.00
22 Sep 2016
Helios User Manual
34
Click on the check box to the left of the word “Attribute” to open the entry window.
When all the values are entered correctly, click on “Send Request” button to perform the data transfer.
Data Example:
These examples are given using the tool mentioned above.
To
read data
from the Helios, use the settings shown in the screen shot below: 0x0E, 4, 101, 3, and click on the “Send
Request” button. 66 bytes of data will be read out of the Helios, they will be displayed in the “Response” table as
shown. The first 4 bytes are an acknowledge from the system, the next 2 bytes are the “Status Register” as defined
above.
Using the “View Log” button, a log of the recent data sent to/from the Helios can be viewed.
Settings used to read data from the Helios:
To
send a command
to the Helios, use the settings shown in the window below: 0x10, 4, 100, 3. Write the command
byte to be used in the “Data(Hex)” window (in the top left position of the table) and then click on the “Send Request”
button.
Examples of values from the Status Register are given above in the Registers and Commands chapter.