MITSUBISHI ELECTRONICS AMERICA, INC.
ST200 Series Technical Support Manual
66
January 2000
2.
Status Monitor ON - During manual acquisition and commissioning with the Status Monitor
ON, the display will change as different steps in the commissioning process are executed.
The displays typically seen are shown as follows. For a listing of all Status Monitor displays,
see Appendix A.
7.6 Commissioning Problems
If a problem is encountered during the commissioning process between the MT and the MSAT
system, the process may be halted or the MT may be deactivated by the MSAT system. If one of
these conditions results, the following displays will be shown and the appropriate action taken as
discussed below.
1. MGSP (internal protocol) error .
−
ACTION
: Press the SND key to resume the commissioning procedure.
2. Commissioning failure (various reasons).
−
ACTION
: Press the PWR key to reset the MT and re-start the whole initialization
procedure (from step 2 in Manual Pilot/GC-S selection, FCN 93,1).
B0XSXX
M:PILOT
B0XSXX
M:GC-S
B0XSXX
COM
B0XSXX
-ON-
B0XSXX
PVT:COM
B0XSXX
IDLE
B0XSXX
COM
COM NG
PushSND
COM NG
PushPWR
