Mitsubishi SRK10YJV-S, Техническое руководство и список запасных частей

Страница: 20 / 69

- -
– 31 –
Installing steps
1.Hook the upper part
of the indoor unit to
the installation board.
2.The unit can be installed
simply by gently push-
ing in the lower part.
5
Securing the indoor unit to the installation board
Wall
Indoor unit
base lower latch
Installation
board
Latch (2 locations)
Installation
board
Indoor unit
•
How to remove the indoor unit from the installation board
1
Push up at the marked portion of the indoor unit
base lower latch, and slightly pull it toward you.
(both right and left hand sides)
(The indoor unit base lower latch can be removed
from the installation board)
2
Push up the indoor unit upward. So the indoor unit
will be removed from the installation board.
The marked portion of the
Indoor unit bese lower latch
Lid
Removal and installation of the front panel
Open/close and detachment/attachment of air inlet panel
Set screws
1
Removing
•
Remove the 2 set screws.
•
Move the lower part of the panel forward and push upwards to
remove. (Remove the 3 latches in the upper section.)
2
Fitting
•
Do remove the air filter.
•
Cover the body with the front panel.
•
Tighten the 2 set screws.
•
Fit the air filter. Carry out in the above order.
1
To open, pull the panel at both ends of lower part and release
latches, then pull up the panel until you feel resistance. (The
air inlet panel stops at approx. 60˚ open position.)
2
To close, hold the panel at both ends of lower part to lower
downward and push it slightly until the latch works, then
push the center portion slightly.
3
To remove, pull up the panel to the position shown in right
illustration and pull it toward you.
4
To install, insert the air inlet panel arm into the slot on the
front panel from the position shown in right illustration, hold
the panel at both ends of lower part, lower it downward
slowly, then push it slightly until the latch works and further
push the center portion slightly.
RMA012A032_Installation.p65 04/05/2010, 17:28 31