Mitsubishi Mirage 2017, Руководство пользователя, Страница: 119 / 305

Tire pressure monitoring system (if so equipped)
5-56 Features and controls
5
N00518900306
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-55, you can resume the previously set
speed by pressing the RES + switch (C) while
driving at a speed of about 25 mph (40 km/h)
or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
 The CRUISE CONTROL ON/OFF
switch is pressed.
 [Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the “OFF” or
“ACC” position.
[Vehicles equipped with the F.A.S.T.-key]
Put the operation mode in OFF or ACC.

Indicator is turned OFF.
N00530201609
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
To resume the set speed
Tire pressure monitoring
system
(if so equipped)
WARNING
 The compact spare wheel does not have a
tire inflation pressure sensor.
When the spare tire is used, the tire pres-
sure monitoring system will not work
properly.
See an authorized Mitsubishi Motors
dealer as soon as possible to replace or
repair the original tire.
NOTE
 The tire pressure monitoring system is not a
substitute for regularly checking tire infla-
tion pressures.
Be sure to check the tire inflation pressures
as described in “Tires” on page 9-12.
 The tire inflation pressure sensor (A) is
installed in the illustrated location.
• On vehicles with Type 1 sensor which has
the metallic air valve (B), replace grommet
and washer (C) with a new one when the
tire is replaced.
• On vehicles with Type 2 sensor which has
the rubber air valve (D), replace rubber air
valve (D) with a new one when the tire is
replaced.
BK0235100US.book 56 ページ ２０１５年１１月２０日 金曜日 午後３時１２分