Mitsubishi MELSEC-F FX2N-1RM-E-SET, Руководство пользователя

Страница: 85 / 140

Program Operating Procedures 8
8-5
FX
2N
-1RM-E-SET Programmable Cam Switch
8.2.4 Insertion
Insertion is performed to the steps Nos. 0 to 6 of the same bank and the same output No.
When data is inserted into an arbitrary step, the steps after the specified step are shifted
backward by 1 step respectively, and the set value is written. At this time, if a set value is already
written to the step No. 7, shift backward is disabled and the error E06 occurs.
Read the head of a program at first, then insert the ON/OFF angle of the output.
[Power ON] [PRG mode]
BANK 0 GO
OUT 0 GO
ON
OFF
2 4 6
ON
OFF
GO
or
3 4 5
GO
STEP 0 GO
Read the program bank
No. 0.
Read the output Y00.
Read the step No. 0.
Start to set ON/OFF of the
output Y00.
Enter the ON angle of the
output Y00.
Determine the ON angle.
Then, the process proceeds
to setting of the OFF angle.
Enter the OFF angle of the
output Y00.
Determine the OFF angle.
The existing set values of the
step No. 0 and later are
shifted backward by 1 step
respectively, and the ON/
OFF set angle of the output
Y00 entered is written to the
built-in EEPROM
CLR
BANK
0
OUT
0
STEP
0
DEG
# # #
*1
ON LED
Lit
OFF LED
Exting-
uished
< Key operation >
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
< Display >
*1 The ON angle of the output Y00 already
registered is displayed.
Nothing is displayed on the DEG to indicate
that the insertion mode is selected.
"246" flashes on the DEG.
The data setting operation proceeds to the next step,
and the data setting panel becomes the following
status.
BANK
0
OUT
0
STEP
1
DEG
000
*2
ON LED
Lit
OFF LED
Exting-
uished
*2 The step No. 1 (former step No. 0) shifted
backward by insertion is displayed.
When the data entered is equivalent to (overlaps)
the existing ON/OFF angle, the error indication
"E02" is displayed. At this time, the data entered is
not inserted.
When data is already present in the step No. 7, the
error indication "E06" is displayed. At this time, the
data entered is not inserted either.
"0" flashes on the DEG.
The ON LED is lit to indicate that the ON
angle setting operation is being performed.
The OFF LED is lit to indicate that the process
has proceeded to the OFF angle setting
operation of the same step.
At this time, "0" flashes on the DEG.
"345" flashes on the DEG.
Select the insertion mode.