Mitsubishi M80 series, Руководство по подключению и настройке

Страница: 353 / 542

M800S/M80 Series Connection and Setup Manual
16 Setup Outline
316 IB-1501269-F
16.2 Flow of Initial Setup
The following flow chart shows the procedures of the initial setup.
(Note)
When setting up with backup files, refer to the chapter of "Data Backup and Restoration".
For other settings, refer to the following chapters:
- Setting the Deceleration Check
- Adjust S-analog Screen
- Device Open Parameter Screen
- SRAM Open Parameter Screen
- Data Backup and Restoration
When using the system lock, refer to the chapter of "Appendix 1: Setting the System Lock".
When using the protection setting, refer to the chapter of "Appendix 2: Protection Setting".
WARNING
Do not cancel the emergency stop before confirming the basic operation.
Refer to section 17
Refer to section 18
Refer to section 20
Refer to section 19
Refer to section 21
Refer to section 22
Refer to section 24
Refer to the Instruction Manual
Refer to section 23
Points
Is the power supply within a specified range?
Is the power supply polarity correct?
Is the connection of the motor power cable and the detector cable correct?
Is the grounding correct?
Carry out the connecting and setting of drive units, batteries and remote I/O units.
Initialize the NC Internal data (SRAM).
Set the parameters on the parameter screen.
Set the date and time on the integrated time screen.
Write the created PLC program to NC's ROM using GX Developer.
Confirm input/output of signals, alarm display and manual operation.
Carry out the setting for establishing the reference position (zero point).
Set the tool entry prohibited range.
Confirm that the spindle operates properly in manual/MDI operation.
Confirm the spindle rotation speed as well.
Start
Confirming the connection between
control unit and peripheral devices
Connecting and Setting the Hardware
Setting the Parameters and Date/Time
PLC Program Writing
Confirming the Basic Operation
Setting the Position Detection System
Setting the Stored Stroke Limit
Confirming the Spindle Operation
Inputting the machining program
End
Setting Up with
M80/M800S SETUP INSTALLER
Refer to section 25
Input the customized data for the handy terminal.
(Note) This procedure is required only when connecting the handy terminal.
Install the custom data (G code guidance data),
start-up screen and user cycle.
If you do not need the installation, go to the next section.
Setting the Handy Terminal