Mitsubishi M80 series, Руководство по подключению и настройке

Страница: 103 / 542

M800S/M80 Series Connection and Setup Manual
4 General Specifications
66 IB-1501269-F
(a) Outline of digital signal input circuit
Both 24V common and 0V common connections are allowed in the digital signal input circuit.
Follow the wiring diagram below for each type.
Input circuit
Input conditions
The input signals must be used within the following condition ranges.
(Note) Input signal holding time: The guide is 40ms or more. The input signal will not be
recognized unless it is held for the ladder processing cycle time or longer.
(E) : External signal, (I):Internal signal
(Note) Set the number of DI points that are simultaneously turned ON to be less than half of the total
points.
If many points are set to be simultaneously turned ON, operation panel I/O unit may be
deteriorated due to the heat.
24V common 0V common
1 Input voltage at external contact ON 6V or less 18V or more, 25.2V or less
2 Input current at external contact ON 3mA or more
3 Input voltage at external contact OFF 20.2V or more, 25.2V or less 3.8V or less
4 Input current at external contact OFF 0.7mA or less
5 Input resistance 5k Ω
6 Tolerable chattering time (T1) 3ms
7 Input signal holding time (T2) 40ms or more (Note)
8
Input circuit operation delay time
(T3 and T4)
3 to 16ms
9 Machine side contact capacity 30V or more, 16mA or more
Connection to 24V common input Connection to 0V common input
X200
X25F
0V
FG
5kΩ
DICOM
X200
X25F
0V
FG
5kΩ
DICOM
24VDC(+)
24V common
Control
circuit
Stabilized
power supply
External contact
24VDC(+)
0V common
Stabilized
power supply
External contact
Control
circuit
CJ37/CJ39 CJ37/CJ39
T1 T1
T2
GND
+24V
T4 T3
(E)
(I)
T1 T1
T2
T4 T3
GND
+24V
(E)
(I)