Mitsubishi FR - S500, Инструкция по эксплуатации

Страница: 108 / 196

98
Terminal function selection parameters
2.9 Terminal function selection parameters
2.9.1 Input terminal function selection (Pr. 60 , Pr. 61 ,
Pr. 62 , Pr. 63 )
CAUTION
•
The frequency can be varied by RH (acceleration) and RM (deceleration)
between 0 and the maximum frequency (Pr. 1 setting).
• When the acceleration or deceleration signal switches on, the set frequency
varies according to the slope set in Pr. 44 "second acceleration/deceleration
time" or Pr. 45 "second deceleration time". The output frequency acceleration
and deceleration times are as set in Pr. 7 "acceleration time" and Pr. 8
"deceleration time", respectively. Therefore, the longer preset times are used
to vary the actual output frequency.
•
If the start signal (STF or STR) is off, turning on the acceleration (RH) or
deceleration (RM) signal varies the preset frequency.
CAUTION
When selecting this function, re-set the maximum frequency according to
the machine.
♦ Related parameters ♦
•
RH, RM, RL signal terminal assignment
⇒
Pr. 60 to Pr. 63 (input terminal function selection)
(Refer to page 98.)
•
Maximum frequency setting
⇒
Pr. 1 "maximum frequency" (Refer to page 64.)
•
Output frequency acceleration/deceleration time
⇒
Pr. 7 "acceleration time",
Pr. 8 "deceleration time" (Refer to page 67.)
•
Time setting for acceleration/deceleration
⇒
Pr. 44 "second acceleration/deceleration time", Pr.
45 "second deceleration time"
(Refer to page 67.)
Use these parameters to select/change the input terminal functions.
Parameter Name
Factory
Setting
Setting Range Remarks
60
RL terminal function
selection
0
0 to 10, 14, 16
Setting is enabled
when Pr. 30 = "1"
61
RM terminal function
selection
1
62
RH terminal function
selection
2
63
STR terminal function
selection
- - - 0 to 10, 14, 16, - - -