Mitsubishi DX-VS1, Руководство пользователя

Страница: 40 / 74

DX-VS1UE User’s Manual
39
3) Network Configuration
This page is used to define network type and set network addresses of DX-VS1UE.
(1) DHCP Client Protocol
DHCP (Dynamic Host Configuration Protocol) is used to manage host address on a network. With t
his protocol, every host on a LAN may share limited official IP address for Internet access. In other
words, every host on a LAN may lease official IP address from DHCP server temporarily. Exactly s
peaking, DHCP server assigns a certain host with an official IP address that is not occupied by other
hosts on the LAN.
DHCP server will assign DX-VS1UE with an official IP address if the LAN is equipped with DHCP
server and “DHCP Client Protocol” is activated.
“DHCP Client Protocol” is used on LAN environment where a DHCP server is in operation. Norma
lly, medium or large sized company runs a DHCP server on LAN environment. For the small sized
LAN, it would be better to use NAT function of HUB.
※
If “DHCP client protocol” is enabled in the network where the DHCP server is not working,
the IP address of DX-VS1UE may become unfixed. In this case, directly connect the DX-
VS1UE to a PC on which the setup program was installed by a crossover cable, start the set-
up program, and set IP address again.
(2) Select Network Interface
This is used to select proper netw
ork interface with which DX-VS1
UE is connected.
If DX-VS1UE is connected with Internet dedicated line, cable modem line or LAN environment, yo
u should select network interface as ‘Ethernet’.
If DX-VS1UE is connected on xDSL line that needs PPPoE process to connect on Internet, administ
rator should select ‘xDSL (PPPoE)’. However the xDSL line doesn’t need PPPoE process, administ
rator should select ‘Ethernet’ even though DX-VS1UE is connected on xDSL line.
In order to get your DX-VS1UE accessed from the Internet, you need to make a contract with ISP and
get a global IP address for your DX-VS1UE.
ENGLISH