(4) Install the crankshaft as follows:
(a) Install thrust plate (I) and two woodruff keys
(2) to the crankshaft and drive in crankshaft
gear (3) by using installer (A).
(b) Install crankshaft to the crankcase.
(5) Install the main bearing caps as follows:
(a) Apply engine oil to the crankshaft journals and
pms, and install the crankshaft in the crankcase secure
ly. Attach main bearing (lower) (I) to main bearing
cap (2) ( front, center and rear) and install the cap in
place aligning it with dowel pin (A) of crankcase.
(b) Measure the crankshaft end play with a thickness
gauge. Replace No.I main bearing if the end play is
out of specification. Tighten main bearing cap bolts
(3) to a torque of 8.5 kgm (61.463 lb.ft).
(6) Install the connecting rod bearing caps as follows:
(a) Install connecting rod bearing {lower) (2) into
cap (I) and apply engine oil to the internal surface of
the bearing, and then install the cap with the match
ing mark on the cap aligned with the mark (A) on the
rod.
