Mitsubishi MOTORS LANCER EVOLUTION 2014, Руководство пользователя

Страница: 146 / 338

Tire pressure monitoring system
Features and controls 5-85
5
 When the Twin Clutch SST control mode
is set to “Sport” mode.
Refer to “Twin Clutch SST control mode”
on page 5-62.
 When the active stability control (ASC)
starts operating.
Refer to “Active stability control (ASC)”
on page 5-76.
Also, the set speed driving may be deacti-
vated as follow:
 When the engine speed rises and
approaches the tachometer’s red zone (the
red-colored part of the tachometer dial).
N00518900234
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-84, you can resume the previously set
speed by pressing the “ACC RES” switch (C)
while driving at a speed of about 25 mph (40
km/h) or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:

The “ON OFF” switch is pressed.
 The ignition switch is turned OFF.
 “CRUISE” indicator light is turned OFF.
N00530201511
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
WARNING
 On vehicles with Twin Clutch SST,
although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
gearshift lever to the “N” (NEUTRAL)
position while driving.
You would have no engine braking and
could cause a serious accident.
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the “ON OFF” switch to turn off the
cruise control and have your vehicle
inspected by an authorized Mitsubishi
Motors dealer or a repair facility of your
choice.
To resume the set speed
Tire pressure monitoring
system
BK0200800US.book 85 ページ ２０１３年２月１４日 木曜日 午後２時２８分