Mitsubishi MOTORS 2018 MIRAGE, Руководство пользователя

Страница: 125 / 354

NOTE
l
On vehicles with M/T, do not move the gear-
shift lever to a position other than the “N”
(Neutral) position or do not release the
clutch pedal while the engine is restarting
automatically. The starter motor will stop
and the engine will not restart automatically.
l If the engine does not restart automatically
or if the engine stalls, the charge warning
lamp and check engine warning lamp will il-
luminate.
If this occurs,
[On vehicles with M/T]
The engine will not restart even if the
clutch pedal is depressed again. While de-
pressing the brake pedal, fully depress the
clutch pedal and turn the ignition switch
to the “START” position or press the en-
gine switch to start the engine.
[On vehicles with CVT]
The engine will not restart even if the
brake pedal is released again. Also, the
indicator blinks, and the buzzer
sounds.
While depressing the brake pedal, move
the selector lever to the “P” (PARK) or
“N” (NEUTRAL) position and turn the
ignition switch to the “START” position
or press the engine switch to start the en-
gine. After the engine is started, the buz-
zer stops.
But the
indicator keeps blinking until
turning the ignition switch to the “LOCK”
position or putting the operation mode in
OFF.
NOTE
For details, refer to “Starting and stopping
the engine” on page 6-15.
l The vehicles equipped with CVT have a
function to prevent the unexpected start of
the vehicle due to creeping, etc., by tempora-
rily keeping the braking force applied when
the engine restarts automatically.
This function is deactivated if the selector
lever is set into “N” (NEUTRAL) position.
While the function is activated, you might
hear operation noise from under the vehicle
or feel a shock from the brake pedal.
This indicates that the system is operating
normally. It does not indicate a malfunction.
CAUTION
l In the following cases, the engine will restart
automatically even if the engine was stopped
by the Auto Stop & Go (AS&G) system. Pay
attention, otherwise an unexpected accident
might occur when the engine restarts.
• Vehicle speed is 3 km/h (2 mph) or higher
when coasting down a slope.
• Brake booster vacuum pressure is low be-
cause the brake pedal is depressed repeat-
edly or depressed harder than usual.
• Engine coolant temperature is low.
• When the air conditioning is operated by
pressing the air conditioning switch.
• When the preset temperature of the air
conditioning is changed significantly.
CAUTION
• When the air conditioner is operated in
AUTO mode where the temperature con-
trol is set to the max. hot or the max. cool.
(for vehicles with automatic aircondition-
ing)
• When the air conditioner is ON, the pas-
senger compartment temperature rises and
the air conditioning compressor operates
to lower the temperature.
• When the air conditioner is changed to the
demister position
• Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
• Push the accelerator pedal (CVT).
•
Battery voltage or battery performance is
low.
• Operate the steering wheel.
• After the engine stop, 3 minute elapse
(CVT).
• Move the selector lever to the “R” (RE-
VERSE) position (CVT).
• Move the selector lever from the “N”
(NEUTRAL) to “D” (DRIVE) position
(CVT).
• Driver's seat belt is unfastened.
• Driver's door is opened.
NOTE
l In the following cases, the engine will not
restart automatically.
Auto Stop & Go (AS&G) system*
6-23
OA0X19E2
Starting and driving
6