Mitsubishi MOTORS 2018 MIRAGE, Руководство пользователя

Страница: 124 / 354

NOTE
l
In the following cases, the indication
lamp will blink to inform the driver and the
engine will not stop automatically:
• Driver’s seat belt is not fastened.
• Driver’s door is open.
• Bonnet is open.
l
In the following cases, the indication
lamp will turn off and the engine will not
stop automatically even if the vehicle is
stopped:
• After the engine starts, the vehicle speed
has not exceeded approximately 5 km/h
(3 mph).
• After the engine start, approximately 30
seconds or more have not elapsed.
• After the engine restarts automatically
and the vehicle stops again within 10 sec-
onds.
• Engine coolant temperature is low.
• Ambient temperature is low.
• When using the heater, vehicle interior
temperature is not warm enough
• Air conditioning is operating and passen-
ger compartment has not sufficiently
cooled.
• When using the air conditioner at the de-
mister position
• When the air conditioner is operated in
the AUTO mode where the temperature
control is set to max. hot or max. cool (for
vehicles with automatic air conditioning).
NOTE
• Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
• Battery voltage or battery performance is
low.
• Check engine warning lamp is illuminated
or the
indication lamp is blinking.
• The selector lever is in another position
than in the “D” (Drive) position (CVT).
• ASC operation indicator and ASC OFF
indicator is turned on (CVT)
• The ABS warning lamp is turned on.
• The selector lever position indicator is
blinking (CVT).
l In the following cases, the engine will not
stop automatically even if the indication
lamp is turned on:
• Push the accelerator pedal.
• Brake booster vacuum pressure is low.
• Operate the steering wheel.
• Brake pedal is not sufficiently depressed
(CVT).
• Parking on steep hill (CVT).
• Parking brake operates (CVT).
l On vehicles with M/T, do not rest your foot
on the clutch pedal while driving because
this will cause detection of clutch pedal
switch malfunction and blinking of the
indication lamp, and Auto Stop & Go
(AS&G) system will not operate.
NOTE
l
If the Auto Stop & Go (AS&G) system oper-
ates while the air conditioner is operating,
both the engine and the air conditioning
compressor will stop. Therefore, only the
blower will operate, the windows may start
to fog up. If this occurs, press the demister
switch to restart the engine.
Refer to “Demisting of the windscreen and
door windows: For quick demisting” on pa-
ges 7-06, 7-13.
l If the windows become fogged up each time
the engine is stopped, we recommend you to
deactivate the Auto Stop & Go (AS&G) sys-
tem by pressing the “Auto Stop &
Go(AS&G) OFF” switch. Refer to “To deac-
tivate” on page 6-24.
l
If the air conditioner is operating, set the
temperature control higher to lengthen the
time that the engine is stopped automatical-
ly.
Automatically restarting the
engine
On vehicles with M/T, depress the clutch
pedal while the gearshift lever is in the “N”
(Neutral) position. The
indication lamp
turns off and the engine restarts automatical-
ly.
On vehicles with CVT, Release the brake
pedal. The indication lamp turns off and
the engine restart automatically.
Auto Stop & Go (AS&G) system*
6-22
OA0X19E2
Starting and driving
6