5. CONNECTION OF SERVO AMPLIFIER AND DIRECT DRIVE MOTOR
5 - 7
(b) Inserting wire
Insert the open tool as follows and push down it to open the spring.
While the open tool is pushed down, insert the stripped wire into the wire insertion hole. Check the
wire insertion depth, and make sure that the cable insulator will not be caught by the spring and that
the conductive part of the stripped wire will not be exposed.
Release the open tool to fix the wire. Pull the wire lightly to confirm that the wire is surely connected.
In addition, make sure that no conductor wire sticks out of the connector.
The following shows a connection example of the CNP3 connector for 2 kW and 3.5 kW of MR-J4 1-
axis servo amplifier.
1) Push down the open tool.
3) Release the open tool to fix the wire.
2) Insert the wire.
Содержание TM-RFM
