Confirming the operation 2-56
The WORK jog operation and the Ex-T jog operation can be switched by setting the parameters WK1-
JOGMD to WK8JOGMD of each work coordinates system.
The respective operations are as follows.
・ When the [+X (J1)] keys are pressed, the robot will move along the X axis (Xw) plus direction on the work
coordinates system.
When the [-X (J1)] keys are pressed, Move along the minus direction.
・ When the [+Y (J2)] keys are pressed, the robot will move along the Y axis (Yw) plus direction on the work
coordinates system.
When the [-Y (J2)] keys are pressed, Move along the minus direction.
・ When the [+Z (J3)] keys are pressed, the robot will move along the Z axis (Zw) plus direction on the work
coordinates system.
When the [-Z (J3)] keys are pressed, Move along the minus direction.
When the X, Y, or Z keys are used, the operation is the same in the WORK jog and the Ex-T jog modes.
WORK jog operation mode
Conventional WORK jog
Ex-T jog
Parameters WKnJOGMD (n is 1 to8) set-
ting
0 (initial value)
1
XYZ key operation
Moves along each axis of the work coordi-
nates system
Same as the conventional WORK jog
C key operation
With the control point position maintained,
the direction changes along the work coor-
dinates system.
While the control point position is
changed, the direction changes on the Z
axis of the work coordinates system (Zw).
AB key operation
The robot does not move.
The robot does not move.
㻗㼄㼣
㻗㼅㼣
㻗㼆㼣
㻙㼆㼣
㻙㼄㼣
㻙㼅㼣
㻗㼆
㻗㼆
㻗㼆
㻙㼆
㼀㼛㼛㼘㻌㼘㼑㼚㼓㼠㼔
㼀㼛㼛㼘㻌㼘㼑㼚㼓㼠㼔
㻯㼛㼚㼠㼞㼛㼘㻌㼜㼛㼕㼚㼠
㼃㼛㼞㼗㻌㼏㼛㼛㼞㼐㼕㼚㼍㼠㼑㻌㼟㼥㼟㼠㼑㼙
㻯㼛㼚㼠㼞㼛㼘㻌㼜㼛㼕㼚㼠
㻙㼄
㻙㼅
㻗㼅
㻙㼅
㻗㼅
㻗㼄
㻙㼄
㻗㼄
㻗㼆
㻙㼆
㻙㼆
㻙㼆
* The direction of the end axis will not change. Move the control point
with a straight line in accordance with the work coordinates system
The jog movement based on work coordinates system
