2Unpacking to Installation
Installation 2-28
3) Remove the base cover B (L).
4) Confirm spare wiring (ADD). Since spare wiring is bundled in the cable tie, if length is necessary, cut the
cable tie.
5) Remove the grommet on the base.
6) Install the connector after letting the cable for spare wiring connection of customer preparation pass to the
cable clamp.
7) Fixing the cable clamp securely to the hole which removed the grommet.
8) Connect the cable for spare wiring connection to the spare wiring.
9) Install the base cover B (R) and base cover B (L) as before. Be careful not to catch any the cables.
When pulling out spare wiring, keep big power from being added to the cable, the air
hose.
Check that the packing is not torn or separated while installing or removing the
cover. If you find that the packing is torn or separated, contact the dealer. If you keep
using the robot with the torn or separated packing, oil mist or the like may get into
the robot, resulting in malfunction of the robot.
When base cover B (R) is installed, please keep too much load from being applied to
the cables inside the robot, and the air hoses.
If too much load is added, the breaking of a wire and the air hose break, and the robot
cannot operate normally.
When base cover B (R) is installed, catch neither the cable nor the air hose.
If the bolt is tightened while it had been caught, the breaking of a wire and the air
hose break, and the robot cannot operate normally. Furthermore, the sealing property
of the packing may be significantly impaired, and the protection specifications may
not be met.
CAUTION
CAUTION
CAUTION
正常な状態
折れた状態
エアホース
Normal condition
abnormal condition
Air hose
CAUTION
