Mitsubishi Electric Q06CCPU-V-H01, Руководство пользователя

Страница: 26 / 38

16
Name Description
1) Indicator LEDs Refer to Section 4.2 for the indicator LEDs.
2)
10BASE-T/100BASE
-TX interface
connector (RJ45)
Connector used to connect the C Controller
module to 10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T
or 100BASE-TX depending on the target device.)
3)
RS-232 interface
connector Connector used to connect the C Controller
module to RS-232.
4)
RUN/STOP/MODE
switch *
2
Refer to Section 4.3.1 for the RUN/STOP/MODE
switch.
5)
RESET/SELECT
switch *
2
Refer to Section 4.3.2 for the RESET/SELECT
switch.
6) EJECT button
Used to remove the CompactFlash card from the C
Controller module.
7)
CompactFlash card
installation slot
Slot used for installing the CompactFlash card into
the C Controller module. (A dummy CompactFlash
card is factory-installed.
*1
)
8) Battery
Used for protecting the standard ROM files, and
backing up the battery-backed-up RAM data and
the clock data.
9) Battery connector pin
For connection of the battery lead wire.
(The lead wire is shipped disconnected from the
connector to prevent battery consumption.)
*1 Keep the dummy CompactFlash card in a safe place after replacing it with an
actual CompactFlash card so that it can be used again in the future when the
CompactFlash card is removed.
*2 Operate the RUN/STOP/MODE switch and RESET/SELECT switch by hand.
Using a screwdriver or any other tool can cause a failure.