Mitsubishi Electric Q06CCPU-V-H01, Руководство пользователя

Страница: 17 / 38

7
(1) The casing of the C Controller module is made of resin.
Do not drop it or not apply strong shock to it.
(2) Do not remove the printed boards of the module from the casing.
Doing so may cause a failure.
(3) Tighten the module fixing screws and the RS-232 cable connector
mounting screw within the following range.
Screw location Tightening torque range Remarks
Module fixing screw (normally
not required) (M3 screw) *
1
0.36 to 0.48N•m ------
RS-232 cable connector
mounting screw (M2.6 screw)
0.20 to 0.39N•m
Depth of screw hole:
L=3.2mm or less
*1 The module can be easily secured to a base unit by the hook on the
module top. However, it is recommended to fix it with the module
mounting screws in a place of high vibration and/or shock.
When installing a dummy CompactFlash card to the C Controller module,
use the dummy CompactFlash card installed when shipping.
Do not use the dummy CompactFlash card that has no "A" printed, as
shown in the figure below, to the products whose serial No. (first four digits)
is "1008" or later. Failure to do so may disable to remove the dummy
CompactFlash card, resulting in damage to the CompactFlash card slot.
A dummy CompactFlash card with "A" printed, as shown in the figure below,
is installed to the products whose serial number (first four digits) is "1008"
or later when shipping.
"A" is not displayed "A" is displayed
No chamfering
"A" is not displayed
No chamfering
No chamfering
Chamfering
"A" is displayed
Chamfering
Chamfering