26
(Con’t)
Table 7-2 Q & A about the table setting tool of PLC for general equipment control
Question Answer
Remarks
Is it possible to display the temperature
in Fahrenheit on this tool?
Yes, it is.
Select “Fahrenheit” on the installation screen before
installing this tool, then install this tool.
(The temperature unit (Centigrade/Fahrenheit) cannot
be changed after installing this tool.)
On which model can 12-17ºC (53-64ºF)
be set for heating?
It can be set only on R407, R410A models of CITY
MULTI (except for S series).
(Note: It cannot be set on MULTI S series.)
Is it possible to use GB-50A?
Yes, it is.
Read this manual changing the word from “G-50A”
to “G-50A/GB-50A”.
The license for “PLC for General Equipment” must
be registered on G-50A/GB50A.
Only Ver.2.90 or later of
GB-50A is released.
The 1ºF temperature
setting function is
available only on
Ver.3.00 or later.
The temperature setting by 1ºF
increment on the PLC of
PAC-YG21CDA is necessary.
Which combination makes it
possible?
The following combination is possible.
This Table
: Ver.1.30 or later
Setting Tool
(when the Fahrenheit is
selected)
G-50A
: Ver.3.00 or later
PAC-YG21CDA
: Ver.2.20 or later
Indoor unit
: Models with 1ºF
/Remote controller temperature setting
function
*The temperature unit
displayed must be the
same in one system.
