Mitsubishi Electric NZ2EX2B-60DA4, Руководство пользователя

Страница: 172 / 228

170
(2) Initial data setting completed flag
After writing parameter data to the remote buffer memory using the REMTO instruction, turn on Initial data setting
request flag (RY9).
Upon completion of the change of operating conditions, Initial data setting completed flag (RX9) turns on.
For the remote buffer memory items that require Initial data setting request flag (RY9) to be turned on and off to
enable written parameter data, refer to the following:
(

Page 37, Section 3.7)
(a) Device number
The device number of this input signal is as follows:
Signal name Main D/A converter module Extension D/A converter module
Initial data setting completed flag RX9
Initial data setting completed flag
(RX9)
(Set value A) (Set value B)
ON
ON
ON
ON
Module power supply
*1
Starts operation
with the set value A
Reads settings from
the non-volatile memory
Starts operation with the set value B
at this timing
Setting value change
by user
Controlled by the D/A converter module
Controlled by the program
*1 Assume that a data link is established simultaneously with turning on of the module power supply.
OFF
OFF
OFF
OFF
Initial data setting request flag
(RY9)
Remote READY (RXB)
*2
Parameter area
OFF
OFF
OFF
ON
*2 If Initial data setting request flag (RY9) is turned on and off, check the turning on of Remote READY (RXB) to start the control.