FUNCTION AND BASIC OPERATION
29
2
NOTE
• If the parameter setting has been changed from the initial value, the set value can be changed from [Set parameter
list].
Turn
to move the cursor to the target parameter, and press
to change the set value.
2.5.4
Precautions for writing the set value
• Basically, change the parameter setting while the inverter is stopped in the PU operation mode or combined operation. The
parameter setting cannot be changed in the External operation mode or during operation. (The parameter setting can be
read regardless of the operation mode.) Note that some parameters can be written even in the External operation mode or
during operation. Refer to the Instruction Manual of the applied inverter.
• In the initial setting, "0" is set in
Pr.77 Parameter write selection
, and thus parameters can be written only while the inverter
is stopped. (The parameters can be read even during the operation.) Note that some parameters can be always written. For
the details of
Pr.77
, refer to the Instruction Manual of the inverter.
• In the following cases, set values cannot be written.
1) When the parameter number selected does not exist in the parameter list
2) When a value outside the setting range is entered
• If writing fails and [Setting Error] appears, press
to reset.
2.5.5
Displaying parameter descriptions (parameter information)
Holding down
while in the screen for setting parameter values displays a description of the parameter.
(SET)
(BACK)
B A C K
S E T
N E X T
- - -
S T O P
P U
E300
Pres value 0
Regener.fnc.slct
Set value 0
（
Hold down
）
Set the applied
regeneration unit,
the terminal used
for power supply,
B A C K
- - -
S T O P
P U
▼
Содержание FR-LU08
Страница 50: ...50 MEMO IB NA 0600539ENG F ...
