Mitsubishi Electric CR1DA-7A1-S15, Стандартные технические условия

Страница: 113 / 144

6Safety
Safety 6-104
(1) External emergency stop connection [supplementary explanation]
(1) Use a 2-contact type switch for all switches.
(2) Install a limit switch on the safety fence's door. With a constantly open contact (a contact), wire to the door
switch input terminal so that the switch turns ON (is conducted) when the door is closed, and turns OFF (is
opened) when the door is open.
(3) Use a manual-return type 2b-contact for the emergency stop button.
(4) Classify the faults into minor faults (faults that are easily restored and that do not have a great effect) and
major faults (faults that cause the entire system to stop immediately, and that require care in restoration),
and wire accordingly.
[Caution] The emergency stop input (terminal block) on the user wiring in the controller can be used for safety
measures as shown in Fig. 6-1 to Fig. 6-4 . Note that there are limits to the No. of switch contacts,
capacity and cable length, so refer to the following and install.
・ Switch contact .......................................... Prepare a 2-contact type.
*1)
・ Switch contact capacity........................ Use a contact that operates with a switch contact capacity of
approx. 1mA to 100mA/24V.
*1)
If you connect the relay etc., rated current of the coil should
use the relay which is 100mA/24V or less. (Refer to
Fig. 6-6 )
・ Cable length................................................ The length of the wire between the switch and terminal block
must be max. 15m or less. Please use the shield line, in case
of the cable may receive the noise etc. by other equipment,
such as servo amplifier. And, since the ferrite core is
attached as noise measures parts, please utilize.
Fig.6-6 ： Limitations when connecting the relay etc.
*1) The minimum load electric current of the switch is more than 5mA/24V.
1A/1B
2A/2B
3A/3B
4A/4B
5A/5B
6A/6B
8A/8B
9A/9B
1A/1B
2A/2B
3A/3B
4A/4B
5A/5B
6A/6B
EMGIN1/2
EMGOUT1/2
Robot controller
Not connected
Error output
Mode output
OP Emergency
stop button
}
RA
RA
RA
7A/7B
}
}
10A/10B
11A/11B
Door switch input
Enabling
device
RA
TB Emergency
stop button
Power supply in the
robot controller
24V
Safety
fence door
Emergency stop switch
(2-contact type)
Peripheral
equipment
Power
supply 24V
Monitor
Circuit
Monitor
Internal emergency
stop circuit
Contactor control
output for additional
axes