Mitsubishi Electric CR1DA-7A1-S15, Стандартные технические условия

Страница: 73 / 144

3 Controller
Parallel I/O interface 3-64
Table 3-13 ： Electrical specifications for the output circuits
The protection fuse of the output circuit prevents the failure at the time of the load short
circuit and incorrect connection. The load connected of the customer should be careful
not to exceed maximum rating current. The internal transistor may be damaged if
maximum rating current is exceeded.
■ Installation method
The expansion parallel input/output interface is installed in the controller. Refer to separate "Instruction Manual/
Controller setup, basic operation, and maintenance" for details on the installing method.
If it installs in the option SLOT of the controller, the station number will be assigned automatically.
SLOT1: station number 0 (0 to 31)
If it uses together with parallel input-and-output unit 2A-RZ361/2A-RZ371, please do not
overlap with the station number of the parallel input-and-output interface.
Item
Specification Internal circuit
Type Transistor output <Sink type>
<Source type>
No. of output points 32
Insulation method Photo-coupler insulation
Rated load voltage DC12V/DC24V
Rated load voltage
range DC10.2 ～ 30V(peak voltage DC30V)
Max. load current 0.1A/point (100％)
Leakage current at
OFF 0.1mA or less
Max. voltage drop at
ON
DC0.9V(TYP.)
Note1)
Note1) The maximum voltage drop value at signal ON. Refer to it for the equipment connected to the output cir
-
cuit.
Respo
nse
time OFF-ON 10ms or less(Resistance load) (hardware response time)
ON-OFF
10ms or less(Resistance load) (hardware response time)
Fuse rating Fuse 1.6A(one per common)
Replacement possible （max. 3）
Common method 16 points per common (common terminal: 2points)
External wire connec
-
tion method
Connector
Exter
-
nal
power
supply
Voltage DC12/24V(DC10.2 ～ 30V)
Current
60mA(TYP.DC24V per common)(base drive current)
+24V/+12V
Output
0V
Fuse
+24V/+12V
0V
Fuse
Output
Caution
Caution