Mitel UC360, Руководство администратора

Страница: 120 / 141

UC360 Administration Guide
104
STEP 3: Configuring DN
Configure the DN using the steps below.
1. Connect the power cable to the UC360 units.
2. At boot-up, each UC360 unit will do the following:
- Request and download the MN_Generic.cfg configuration file from the HTTP server
and overwrite existing setting values with all the generic file values.
- Request and download its specific configuration file MN_<MAC Addr>.cfg from the
HTTP server, and overwrite existing settings values with all the defined values in this
configuration file.
Notes: If the UC360 requests a configuration file that is not on the HTTP server, settings
on the UC360 do not change.
When a UC360 uses configuration files, you can still change settings manually; however,
if these settings are also defined in the configuration files, the files overwrite manual settings
the next time the phone reboots if the file is modified after the manual changes were applied.
If the HTTP Server does not support sending a valid LastModified timestamp with the
response to GET the XML file then the check for modification before downloading is
presumed to indicate a change to the XML file and it will always be downloaded.
When using mass deployment (xml cfg) to update the UC360, perform a second reset after
doing a factory data reset.