Mitel SmarT-1 380-003-FBCLXX, Инструкция по установке и программированию

Страница: 31 / 94

General Notes on Programming
8380-383-115-BA
Issue 2, June 1999
30
6. 7. 1. Conditions
The following conditions apply when using Data Verification:
•
the Dialer must be fully operational.
• the PC must be set for 300 bps
• you only need to enter 902 once. You will remain inData Verification provided you do not
exceed the 2 minute programming timer, or manually exit Data Verification.
6. 7. 2. Procedur
To use Data Verification:
1. Enter Programming Mode, the following screen appears:
2. After entering Programming Mode, the Dialer is ready in Data Verification Mode.
3. Enter the desired parameters. When you enter the parameter the data associated with that
parameter appears opposite the entry. If there is no data for the parameter, nothing is
displayed. The Dialer automatically moves to the next entry position. For example, the
value for Register 123 may be 8, as shown below:
6. 8. Exiting Data Verification (907)
To return to programming mode enter 907. You can re-enter the Data Confirmation mode by
entering 902.
Note: When verifying routes, you cannot enter 5XX, where 5 is the indication that you wish to
verify all the routes. Each Route must be verified individually.
6. 8. 1. Example For Data Verification of Register R54
Enter Programming mode #0
✳ ✳ ✳ ✳
Enter 902
Enter 154 for Route 0
Enter 254 for Route 1
Enter 354 for Route 2
Enter 454 for Route 3
Enter 554, will return a “?”
8380 REV 156B01 COPYRIGHT 1991-1999 MITEL INC. ALL RIGHTS RESERVED.
Serial Number BC00000000
ENTERING PROG. MODE
V>
P> 902
V> 123 8