Orienting the Remote Transmitter
•
The unit must be programmed to recognize a specific remote
transmitter.
•
Prior to this step, the DIP Switches on the transmitter should be
repositioned (from factory setting) to ensure that another
transmitter will not activate unit.
•
In the LRN Menu, under SET-UP, hold down Green
►
button
for 5 seconds and wait for countdown to begin. Press and hold
any button on the remote transmitter. When DONE flashes in
the display, the transmitter is programmed.
Switches are located on back side of transmitter, on side
opposite the antenna, under a small plastic cover. Use the
end of a pen to change the position of one or more of the
switches.
Section 4
Using the Remote
Section 4
Using the Remote
MIST Button
•
Activates a REMOTE MIST for the duration defined in the SET-
UP menu.
•
An agitation cycle will precede the REMOTE MIST if the Remote
Agitation Duration (SET-UP
RAG) is set to a value greater
than 0 seconds.
•
NOTE: on pre-2012 systems, agitation duration before a remote
mist is fixed at 15 seconds.
•
If a Zone Kit is installed, refer to instructions included with the
zone kit to configure how the remote transmitter works.
STOP MIST Button
•
The STOP MIST button stops the current operation of the unit. It
will not change the System Mode from ON or AUTO to OFF.
SKIP NEXT MIST Button
•
The SKIP NEXT MIST button enables the next programmed
AUTO MIST to be skipped. The controller will display “SKIP.”
•
While the unit is flashing SKIP, it will still respond to a Remote or
MANUAL MIST.
•
When an AUTO MIST has been skipped, the unit will return to
the normal display, with a flashing “sunshine” icon in the lower
right corner of the display.
•
You may only skip one mist at a time. That is, pushing the SKIP
NEXT MIST button multiple times will not cause multiple AUTO
MIST cycles to be skipped.
•
Clear skip by holding down the
▲
button on the controller for 3
seconds.
