Mirapoint RazorSafe 170, Руководство по оборудованию

Страница: 20 / 76

About Your Appliance
20
1
The amount of
system memory has
changed. Memory has been added
or removed or a
memory module may be
faulty. If memory has been added or
removed, this message is informative
and can be ignored. If memory has not
been added or removed, check the SEL
to determine if single-bit or multi-bit
errors were detected and replace the
faulty memory module. See
Troubleshooting Memory on page 65.
The following
DIMMs should
match
in geometry:
x , x , ...
Invalid memory
configuration. The
specified memory
modules do not match
in size, number of ranks,
or number of data lanes. Ensure that the memory modules are
installed in a valid configuration. See
General Memory Module Installation
Guidelines
on page 42.
The following
DIMMs should
match
in rank
count: x , x , ...
The following
DIMMs should
match in size:
x , x , ...
The following
DIMMs should
match
in size and
geometry:
x , x , ...
The following
DIMMs should
match
in size and
rank count: x , x , ...
Thermal sensor not
detected
on x.
A memory module
without a thermal
sensor is installed in the
specified memory slot. Replace the memory module.
Processors on page 47.
Time-of-day clock
stopped. Faulty battery or faulty
chip. See Troubleshooting the System
Battery on page 63.
Time-of-day not set
- please run SETUP
program. Incorrect Time or Date
settings; faulty system
battery. Check the Time and Date settings. If
the problem persists, replace the
system battery. See
System Battery on
page 52.
Timer chip counter
2 failed. Faulty system-board. See Getting Technical Support on
page 3.
Table 4 Appliance Messages (Continued)
Message Causes Corrective Actions