Mirapoint RazorSafe 170, Руководство по оборудованию

Страница: 52 / 76

Installing Appliance Components
52
2
Removing the Power Supply Blank
If you are installing a second power supply, remove the power supply blank in bay
PS2 by pulling outward on the blank.
c
To ensure proper appliance cooling, the power supply blank must be installed in
power supply bay PS2 in a non-redundant configuration. Remove the power supply
blank only if you are installing a second power supply.
Installing the Power Supply Blank
c
Install the power supply blank only in power supply bay PS2.
To install the power supply blank, align the blank with the power supply bay and
insert the blank into the chassis until it clicks into place.
System Battery
Removing the System Battery
w
There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer.
See your safety information for additional info.
c
Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized is not covered by your warranty.
Read and follow the safety instructions that came with the product.
To remove the system battery:
1. Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2. Open the appliance. See Opening the Appliance on page 30.
3.
Locate the battery socket ( Figure 21 on page 72).
4. Push the metal tab away from the battery until the battery pops out ( Figure 18
on page 53).
c
Avoid damaging to the battery connector by firmly supporting the connector
while removing a battery.