GUIDE TO INSTALLATION AND OPERATION
RCP-200 |
15
The LOOKUP LIST area contains a list of appservers that were previously entered, along with a button to REMOVE
appservers from the list.
To ADD an appserver to the list:
4. Use the four control knobs in the ADD TO LIST area to dial in the IP address of the new appserver. The address
will appear in the TO ADD data box
5. Press the ADD control knob; the appserver will be added to the list.
To REMOVE an appserver from the list:
6. Select the appserver from the list by turning the left-most control knob
7. Press the REMOVE control knob; the selected appserver will be removed from the list
To end the configuration process and return to normal operation:
8. Push the CONFIG button between the two screens.
Any devices available at the selected servers will appear in the device lists on the left-hand screen.
Specify Kaleidos for the RCP-200
RCP-200 can operate Miranda’s Kaleido multi-viewer processors. A special screen is provided to enter ip addresses of
Kaleido units.
When you have decided which Kaleidos you will access, proceed as follows:
1. Press the CONFIG button, located between the two screens on the front of the RCP-200.
2. Touch the COMM category on the right-hand screen
3. Touch the KALEIDO DISCOVERY tab on the right-hand screen
