Miranda imagestore 750, Руководство пользователя

Страница: 183 / 423

Imagestore 750 User Manual Front Panel Operations
Miranda Technologies Inc. Page 183
To adjust the number, refer to the IP Address section (see above).
Pressing
enter to accept the change will then display the message ‘ Updating
EEPROM ’ shortly followed by ‘ Restart to apply new setting ’.
Restart the Imagestore 750 by selecting ‘Software Reset’ or ‘Restart System’.
NTP Server
This option allows the clock in the Imagestore 750 to be set from a Network
Time Protocol server located on the network. The clock is checked once
every 1024 seconds; however if the clocks are seen to be drifting then the
update period will be automatically reduced to a minimum of 64 seconds.
Using the joystick arrows
W X
enter the IP address of your NTP server. (See
IP Address).
The number is in four blocks separated by full stops, for example:
>255<255.255.255
Logging Server
This option allows the user to set the IP address of a remote syslog server,
permitting log files to be logged externally. Setting up of a syslog server is
well documented on the Internet, however Support can also provide details.
Using the joystick arrows
W X
enter the IP address of your logging server.
(See IP Address).
The number is in four blocks separated by full stops, for example:
>0<0.0.0
Local Logging
This option enables or disables local logging to the hard disk or solid state
storage. Disabling local logging this can reduce wear to the internal hard disk
or solid state storage, but it should usually only be disabled if a logging
server has been set up (see above).