Mira Mode Maxim, Инструкция по установке и эксплуатации

Страница: 19 / 26

37 36
Carefully remove the slide bar
assembly and tighten the screw
on the back of the top bracket to
secure in position.
Refit the fit the slide bar assembly
in position.
The outlet pipe must protrude 18mm
(± 2mm) from the finished wall surface
and a minimum 35mm from the ceiling.
Note: Cut the pipe to the correct
length and remove any burrs.
Mark the positions of the backplate
fixing holes.
Caution! Be aware of hidden pipes
or cables.
For solid walls drill the fixing holes for
the backplate with a 6mm drill and
insert the wall plugs (supplied). For
other types of wall structure alternative
fixings may be required (not supplied).
10
2 3
Installation: Rear Fed Deluge Head
Fix at convenient height for all users. Position so that water sprays down the centre of the
bath, or away from the opening of a shower cubicle. Make sure that the water sprays away
from the Controller.
Note: Make sure that the deluge head is not installed over the handshower.
1
Secure the assembly in position with
the screws. The top securing screw
tightens clockwise, the bottom one
anti-clockwise. Do not overtighten.
Fit the shower hose to the handset.
Make sure that you fit the shower
hose and flow regulator.
Fit the cap to the top of the slide bar
and fit the hose to the bottom outlet.
Note: Do not fit the handshower
until after pipework has been
fully flushed through. Refer to
‘Commissioning’.
11
13 12
Top Bracket
Tighten screw
to secure.
Note! Do not
overtighten
Rear view of
Top Bracket
Flow Regulator
Washer
Minimum distance
to ceiling 35 mm
18 ±2 mm