16
InsTaLLaTIon
refer to section:
'Important safety Information'
first.
This installation covers all models of the Mira advance aTL Thermostatic
shower.
1.
e l e c t r i c a l s u p p l y
is turned off at the
mains.
2.
determine the shower
p o s i t i o n , l e a v i n g
adequate space for
maintenance.
3.
remove cover screw.
4.
remove the cover
and splash guard.
determine supply pipe
position and if required
cut a slot in the case
for the rising supply.
5.
Make provision for
signal cable to connect
to shower drain pump
(if applicable). also
refer to whale drain
pump instructions.
6.
Turn inlet connector
to suit supply pipe.
Do
not
trap green wire.
7.
c o m p l e t e a n y
soldering required
away from appliance.
9.
When fitting to a
tap connection, use
adaptor (supplied).
Do
not
fit fibre washer.
8.
Flush a minimum of
10 litres (2 gallons)
through pipework prior
to connection.
10 mm
100 mm
