Mira 1.1532.327, Инструкция по установке и эксплуатации

Страница: 8 / 32

8 1079321-W2-G
Electrical
Power supply - 230-240 V at 50 Hz, fused at 3 Amps, via a double pole fused switch
(not supplied) with a minimum contact separation of 3 mm for each contact.
Electrical Connections - Terminal block will accept cable up to 2.5 mm². Minimum cable
size (cross-sectional area) required under normal installation conditions is 1 mm
2
.
Power Consumption - 150 W maximum.
Plumbing Connections
Inlet Connections
Outlet Connection - 1/2” BSP male.
Operating Parameters
Cold water temperature - Maximum inlet temperature 30 °C
Hot water temperature - Maximum inlet temperature 65 °C
Warning! For safety reasons set the maximum temperature of the stored hot water to
between 60 and 65
requirements and will minimise the deposition of scale in hard water areas.
Temperature Control - The maximum temperature stop is set to 41 °C. Depressing
the override button overrides the maximum temperature and allows the showering
temperature to be increased by 5 °C to approximately 46 °C.
The showering temperature will be maintained to within 1 °C of selected temperature
with a 10 °C change in the hot or cold water supply.
levels in approximately 2 seconds. The hot supply must be at least 12 °C above the
blend temperature for shut down to seepage to occur.
The showering temperature will be maintained to within 1.5 °C of the selected showering
temperature when the pressure between inlet and outlet is halved on either the hot
or cold side.
Operating pressure
Minimum maintained pressure -
1.0 kPa (0.01 bar) or 100 mm head of water.
Maximum maintained pressure -
50 kPa (0.5 bar) .
Maximum static pressure -
100 kPa (1 bar) or 10 m head of water.
Duty Cycle - The Mira GO Thermostatic Power Shower pump is now continuously
temperatures become too high due to abnormally high supply voltages.
Noise - The acoustic noise from the pump motor has been reduced with the use of
will also affect the perceived noise level; solid walls will provide a quieter operation.
Maximum total head delivered – 1.5m
Approvals
The Mira GO Thermostatic Power Shower complies with UKCA & CE
standards.
SPECIFICATIONS
2 x 15 mm Push-fit manifold.
°C. Such temperatures are considered sufficient to meet all normal
If the cold supply fails the thermostatic mixer will shut down flow of water to seepage
rated. The motor is fitted with a self-resetting thermal trip, designed to operate if motor
anti-vibration rubber feet and rubber wall plugs. The type of wall the appliance is fixed to
Approvals
The Mira Vigour Thermostatic Power Shower complies with UKCA & CE standards.