Mira 1.1532.327, Инструкция по установке и эксплуатации

Страница: 19 / 32

19 1079321-W2-G
The unit must not be run dry. Before proceeding any further with the installation the
shower unit must be commissioned.
1.
of the shower unit.
Caution! Do not over tighten.
2. Turn on the water supplies and check
for leaks.
3.
Switch on the electrical supply.
4. Tu r n t h e o u t e r f l o w c o n t r o l
anticlockwise
5. Rotate the inner temperature control
anticlockwise to check the hot supply
and clockwise to check the cold
supply.
6. clockwise to the
OFF position.
7. T h e s h o w e r u n i t i s n o w
commissioned.
Hose Washer
Hose
Outer Flow Control
Maximum
Flow Position
Outer Flow Control
OFF Position
Inner Temperature
Control
Temperature Indicator
Cooler Warmer
Connect the flexible hose to the outlet
to full flow.
Turn the flow control
Maximum Temperature Setting
It may be necessary to adjust the maximum temperature for site conditions to make
sure of safe showering from the unit. Make sure that the hot water temperature is at
least 12 °C above the required temperature for correct operation of the thermostatic
power shower.
To reset the maximum outlet temperature follow the sequence below :
1. Tu r n t h e o u t e r f l o w c o n t r o l
anticlockwise
2. Turn the inner temperature control
knob anticlockwise to the maximum
temperature stop. Do not depress
the override button .
3. Check the shower temperature.
4.
If the maximum temperature requires
adjustment then remove the outer
control knobs. Slide the end of the
flow control, lever the outer flow
control and the inner temperature
control knobs off together from the
shower unit.
5. Remove the small label covering the
retaining screw on the temperature
hub. Unscrew the retaining screw and
remove the temperature hub.
Note! This will void the factory
setting.
Outer Flow Control
Maximum
Flow Position
Temperature Hub
Retaining Screw
Temperature
Hub
Inner Temperature Control Knob
Maximum Temperature Position
to maximum flow.
flow control and the inner temperature
push-fit release tool under the outer