Mira 1.1532.327, Инструкция по установке и эксплуатации

Страница: 26 / 32

26 1079321-W2-G
Warning! There are no user serviceable components beneath the cover of the
appliance. Only a competent tradesperson should remove the cover.
Before removing the cover the electricity supply must be turned off at the mains and,
if applicable, the appropriate circuit fuse removed. Mains electrical connections are
exposed when the cover is removed.
Before replacing any parts make sure that the underlying cause of the malfunction
has been resolved.
MAINTENANCE
SPARE PARTS
147.67 Check Valve Pack
453.01 Cartridge - Thermostatic
453.03
453.07
453.08 PCB Assembly - Power
453.12
453.13
453.14 Filter/Cap Assembly
453.15
453.22
453.23
453.24
453.28 Outlet Elbow Assembly
1532.332 Control Knob Assembly
1532.335 Cover
Motor Pump Assembly - components identified ‘A’
Inlet Manifold Assembly - components identified ‘B’
Harness Assembly - Concentric - components identified ‘C’
Solenoid Valve Assembly - components identified ‘D’
Seal Pack - components identified ‘E’
Stud Wall Fixing Kit (Push-fit Release Tool, 3 x Fixing Screws,
3 x Rubber Wall Plugs) - components identified ‘H’
Mixer Valve Body - components identified ‘F’
Inserts/Rubber Feet Pack - Power - components identified ‘G’
Cleaning
It is IMPORTANT to keep the Showerhead and Hose clean and free from blockage
to make sure your shower performs to its optimum. The showerhead MUST be
regularly cleaned and the hose MUST be regularly inspected to ensure there is no
internal collapse or blockage that could reduce the flow.
Many household and commercial cleaners, including hand and surface cleaning
wipes contain abrasive and chemical substances that can damage plastics, plating
and printing and should not be used. These finishes should be cleaned with a mild
washing up detergent or soap solution, and then wiped dry using a soft cloth.
Always read the IMPORTANT SAFETY INFORMATION for your shower.
Cleaning the showerhead
Use your thumb or a
soft cloth to wipe any
limescale from the
soft nozzles
Unscrew the hose from
the showerhead and
the shower outlet.
Inspect the hose.
Warning! Failure to keep the showerhead nozzles clear or inspect the hose for
blockage or internal/external collapse can restrict the flow rate from the shower.
This may cause damage to the shower or result in the temperature delivered to the
user rising to unsafe levels with a risk of scalding. You MUST ALWAYS check the
temperature before using the shower.